Schlagwort-Archiv: CBT

Vendor: Oxballs

Construction

The Oxballs Trough is a roughly cuneiformed piece of FLEX-TPR measuring 6,4cm at the widest part by 13,5cm. At the upper end is a 3,9cm by 2,2cm hole with a recess for your seminal duct through where you put your penis. Below that is the 3,7cm by 2cm hole for your balls which provide about 1,7cm of stretch. From that hole runs a reinforced, thick piece of FLEX-TPR to a 3,6cm by 2,2cm bulge on the end of the toy.

Playing with it

I have to admit when I have first gotten this item from Oxballs as a gift because there were some problems with an order I didn’t really know what to do with this toy. But after I figured out how to use it properly it because one of my favorite toys especially when traveling.

The initial application is making jerkin off more exciting: The hole for the dick restricts the blood flow a bit thus it works a bit as a cockring and the ball hole has a bit of a stretch and squeezes the neck of your sack so your balls bounce a bit when you start to wank (only for that you have to love this toy). But the piece de resistance of this toy is the bulge on the end. While jerking the bulge slaps against the part of your prostate located just below the perineum. With the toy come instructions how to use it properly and on that Oxballs says you should put lube on the bulge. I have tried it with several water and silicone lubes and it didn’t alter the sensation in any way; it only made clean-up more difficult.

So much about the vanilla application. I have used and had the Trough on me in a number of cum control sessions. For milking it is a great toy: The pressure of the cock hole helps sustain the erection and the bouncing balls and prostate stimulation supports the effort of squeezing another orgasm out off the sub. When it comes to edging the usefulness of this toy greatly depends on your style. When you mostly do head polishing or frenulum stimulation the Trough does nothing for you. If you jerk, you have to be careful because the bouncing balls and the bulge have an own momentum which is often enough to make the sub cum.

For other CBT purposes it as always depends on the sub’s balls. If his balls are tight the little stretch is enough to make them firm enough for good squeezing, twisting, hitting, etc. If you should put conductive silicone loops around the balls and the shaft depends on how brave you are and how well made your electro box is made. When jerking the two poles can meet thus hot-wiring your box. A friend has done that accidently with his ET232 and had no problems but with a less well-made box it can fry the internals.

For all different aspects of play the manifestation or intensity of the sensation depends greatly on the position of the sub: When sitting down you have to sit so far forward and when laying down the legs must be spread apart so much that the bulge can still move freely which can be uncomfortable (but maybe you want to go there). For an extensive scene I would recommend either standing legs spread a bit apart or sitting on a rim or gynecological examination chair.

The Oxballs Splitsling

Vendor: Oxballs

Construction

After having taken a look at just a stretcher from Oxballs today we add a divider with the Splitsling which is also made out of their exclusive extremely stretchy FLEX-TPR.

Like the Nuttsling it has three holes. Through the first you have to put both your dick and balls. It is slightly smaller with approx. 3,9cm by 2,7cm. The profile is also oblique so the stretcher fits nice and tightly onto your body. On the bottom of the hole there is a small recess for your seminal duct so even if you have a really big dick thus pressing the material tightly onto your genitals piss and cum can flow freely. Across from the first hole there is another one through which you put your dick. It is 3,6cm by 2,2cm and also has a small recess. Perpendicular to these holes is the stretcher which has less stretch than the Nuttsling with approx. 2,4cm of stretch. The tube is 3cm wide and on the bottom there is a 1cm wide piece of FLEX-TPR which functions as a divider. Because it is so flexible it works even with large balls.

Sadly Oxballs doesn’t (yet?) offer the Splitsling in the stretcher size of the Nuttsling or as the updated design of the Cocksling-2. If you need more stretch and a divider take a look at their Splitz.

The Seminal Ducts on the Back and Bottom of the Dick Hole

Playing with it

I usually praise Oxballs toys for long-term wearability if you choose a toy which doesn’t stretch too much for your sack. In this case if you have a larger sack and especially large balls, try this toy out extensively if you can before you buy it. The FLEX-TPR is stretchy enough to accommodate even large sacks but it is made to get back into shape so the push of it towards your body can be more intense than you would expect from such a soft material.

But if it fits the stretcher is like any other toy from Oxballs: Comfortable to wear (again: if shaved properly!) yet it pushed your sack down and balls apart enough to make them ideal targets for torturing them. Because unlike with leather divider straps this divider is also about 1cm thick. Through the volume you can tie conductive silicone loops around the individual balls without them making contact which can lead to a… unique sensation for the sub. Also I found the FLEX-TPR a bit more practical when it comes to playing with wax and water compared to leather. One thing the FLEX-TPR can’t do is being used for adding weights or bondage! In theory you could put a shackle onto the divider as a D-ding substitute but the FLEX-TPR will when pulled on either stretch or tear. If you want to add bondage or weights please use suitable rope (like fat shoe laces) for another layer of bondage.

Putting the Splitsling on is basically the same way like the Nuttsling. But instead of pushing the back end on the perineum I found it easier to press the divider between your balls and then pull the rest over the sack. Otherwise getting the balls sorted out is kind of complicated.

Vendor: Oxballs

Construction

The Stretcher with the Penis openen

The last couple of weeks I have been reviewing leather ball stretchers. Today’s toy is made out of Oxballs’ exclusive super-stretchy FLEW-TPR.

The Nuttsling has three holes. Through the first you have to put both your dick and balls. It is approx. 4,1cm by 2,9cm and oblique so the stretcher fits nice and tightly onto your body. On the bottom of the hole there is a small recess for your seminal duct so even if you have a really big dick thus pressing the material tightly onto your genitals piss and cum can flow freely. Across the first hole is the second one through which you put your dick. It is 3,3cm by 2,2cm and also has a small recess. Perpendicular to these holes is the stretcher which provides approx. 3,2cm of stretch. Halfway through the 2,5cm wide tube there is a bulge for a snug fit of your balls. Around all holes is a piping like bulge which makes wearing the Nuttsling more comfortable.

The back of the Stretcher with the Recess for the Seminal Duct

If you balls are really tight, Oxballs offers a model with a bit less stretch called the Cocksling. There is a new version out the Cocksling-2 which has “supporting beams” all around the stretcher tube for a bit extra stretch. I can’t wait to get my hands on a hopefully soon to be made Nuttsling-2.

Playing with it

This stretcher is made for really long-term wearing due to the material properties. The TPR is very flexible. Due to the bulge in the middle the stretch is good but still the stretcher will still adjust (to a certain level) to how much your balls can take. This also matters when you start moving you balls (jerking off, hitting, etc.): Unlike leather or stiff rubber stretchers the TPR will give in making it a bit more comfortable to wear (and in my testees’ opinion the balls bounce more while jerking off). Also unlike leather this stretcher doesn’t care about sweat and piss. But the comfort is only try when you have shaved (not trimmed!) your pubes. When pubic hair gets caught between the skin and the TPR and you start to move it feels like pulling on your pubes (which might be what you want).

So, how do you put this stretcher on? The method which works best for most of my testees and me is

1. putting both forefinger and middle finger inside the stretcher tube,
2. squeeze and pull it apart,
3. push the back against the point where your perineum meets your scrotum,
4.  pull the tube over your balls,
5. than your dick through the hole and
6. finally adjust the tube which will probably still be a bit deformed after the squeezing.

Even though this might sound complicated once you have figured it out this stretcher is actually the easiest I own to put on because you don’t have to deal with gripping your balls with one hand, put the leather around it with the other, than take care that no skin is in between the snap buttons while making sure that both balls stay below, etc.

The Bulge inside the Stretcher Tube for a snug and firm fit

I have already talked at length what you can do with balls inside a stretcher. But due to the flexible material squeezing the balls of your sub is easier than when he wears a stretcher made out of a stiffer material.

Because TPR toys can be used with most forms of lube (water, oil, silicone based and water/silicone hybrids) I use the Nuttsling for electro play. For electro CBT I mostly rely on simply silicone loops. In order not to short-circuit them they mustn’t touch so I put one loop just below the bulge at the ending of the stretcher, one just behind the bulge of the dick-and-balls hole and the fun can begin. And if I need water-based lube for better conductivity the TPR won’t mind.