Head Harness for AVON Gas Masks

The VAST Head Harness for AVON Gas Masks in Red Superior Latex

Vendor: VAST

Happy Nikolaus Day! As promised last Sunday, here is a short bonus review of a an add-on for your AVON S10/ FM12 gas mask.

Construction

The head harness has the same six-point-shape of the original rubber (S10) or mesh (FM12) head harness of the AVON gas masks. The main difference is that you install roller buckles mounted on small latex straps using screw rivets into the clamp locks for adjusting the original head harness. The roller buckles come in plain or locking variety without a surcharge depending on your taste. Using these roller buckles you can adjust the main body of the head harness. The six straps attached to the back piece are quite long so they will fit even large heads. Since this head harness is one size fits all, on really small heads the access strap can flap around a bit. If you want to learn how to fit this head harness on your gas mask, I posted a little guide here (scroll down to the second half of the guide).

A Roller Buckle mounted onto an FM12’s Clamp Lock

Since VAST uses it’s own aramide reinforced Superior Latex for this head harness you cannot shorten the straps on your own. The good thing is because of the reinforcement you can really tighten or pull on it HARD. You will rather rip the locks off than then tear the rubber so don’t exert too much force.

Off the rack the harness comes in the “standard” fetish colors black, red and yellow. But I am sure you can ask for custom colors within the 4D Latex color scheme.

Playing with the Head Harness for AVON Gas Masks

For me this head harness is an innovative and breath-play suitable answer to the often asked question “Where can I a hood attached to my AVON gas mask?” A few years ago many rubber makers used to attach hoods to S10/ FM12 gas masks with a zipper at the back for a full rubber drone look. Currently I think only Blackstyle in Berlin and Regulation in London do this anymore if at all. Attaching a hood was often a not quite satisfactory thing because getting the fit right was difficult: Unlike a flexible rubber hood which wraps around the head, there is a big, stiff “front piece” which determined the fit of the rest of the hood. One result of this was that the actual gas mask did not create a full seal, making it unsuitable for breath play.

The Head Harness Attached to a Breathing System-ready FM12

With this head harness made out of latex you can create a hot looking, full rubber feeling yet still gas-tight configuration. For this put on your tight fitting latex hood as a base layer and then fetter the gas mask over it. This way your head is completely enveloped in rubber but the gas mask fits tight enough for proper breath play. Despite being aramide reinforced the rubber is soft so lying on the head harness is not uncomfortable. The rubber buckles are on the side so even the locks on the locking ones don’t press into your head when bound to the back.

The Back Piece with the Long Straps

The rubber base layer also keeps the head harness’ rubber from touching your skin and hair so you don’t need to clean it. Since oils and fats which are present on your skin and hair can destroy rubber over time, you need to clean latex after skin contact. Keep this in mind when using the head harness on bare skin.

Despite the wide range of adjustability I strongly recommend initially getting the right size gas mask size for your head! In order to work properly, the gas mask needs to create a tight seal around your face. Choosing a too large or too small gas mask will make this seal difficult, especially around the chin regardless how strong you tighten the straps.